knaxuslearn · build · ship

Roadmaps / STM32 / Setup and lab safety

Read first

Setup and lab safety

Order the board first. The NUCLEO-G474RE is an active product (ST product page, checked 22 Nov 2026) and stock varies by seller, so check before you plan Week 1.

ItemWhy you need itTypical price (estimate)Needed?
NUCLEO-G474RE (STM32G474RE, Cortex-M4F at 170 MHz, 512 KB flash in two banks, 128 KB SRAM including 32 KB CCM SRAM; on-board ST-LINK/V3E)The board and its debuggerUS$17 to 31 by seller (checked 22 Nov 2026)Yes
USB cable for the board's ST-LINK connector (Micro-B on the revision in UM2505; check yours)Power, debug and a virtual serial port$4Yes
8-channel USB logic analyzer that works with sigrok (typically 24 MHz sampling, about 42 ns resolution)An independent check of timing and of the power-cut drills$12Yes
Breadboard, jumper wires, resistors (10 kΩ x4, 1 kΩ, 100 kΩ) and capacitors (100 nF x3)The RC plant, the disturbance load and the safe-state pull-down$12Yes
Delay-relay module (3.3 V trigger, holds the relay open for a set time such as 1 s, own 5 V supply)The board triggers a cut that lasts after the board dies (Week 15)$5Yes, from Week 15
A USB cable with the +5 V wire routed through the relay above (or a hub with per-port power switching that uhubctl supports; not all hubs do)Power cuts in Phase 4$5 to 20Yes, from Week 15
CAN transceiver module (3.3 V logic) and a USB-to-CAN adapterReal CAN traffic in Week 10; the core path uses FDCAN internal loopback$15 to 30Optional
OscilloscopeEasier ripple and latency views$0 to 400Optional

The minimum kit (everything marked Yes) is about US$55 to 85. Everything in the milestone runs on the board and a laptop; nothing needs cloud spend. Read UM2505 (Rev 7, May 2026) to see whether your board has a CAN transceiver before you rely on one.

RiskRule
Wrong voltage destroys a pinUse 3.3 V signals. Check each pin you use in the datasheet: not every pin is 5 V tolerant, and analog pins are not.
Readout protection locks you outNever set readout protection level 2 (irreversible). Level 1 can be removed, but removing it erases the flash. Leave both alone until Phase 4.
Wrong option byte makes the board look deadRecord the factory option bytes in Week 1 with STM32CubeProgrammer. Recovery is to connect under reset and rewrite them. Do not change boot or write-protection bits you cannot explain.
Relay rig5 V only, never mains. Use a spare cable, cut only its +5 V wire, and power the relay module from a second USB port, not through the cable it cuts. Confirm each cut: the board's LED goes dark and the analyzer's rail channel goes low.
Power-cut drills corrupt flashRun them on your own board only, from a recorded known-good image on your laptop. A cut during an erase can leave a page half-written, which is what the drill tests.
SecurityThe G4 has no hardware secure boot. It offers readout protection, write protection and a securable memory area (datasheet). Plan signed images and a small attack surface instead (ADR-6).