knaxuslearn · build · ship

Roadmaps / BeagleBone / Setup and lab safety

Read first

Setup and lab safety

Order the board first. Lead times vary: in early 2026 Mouser listed a 12-week factory lead time for the BeagleBone Black Industrial variant, and the standard Rev C board was in stock at some sellers and back-ordered at others. Check stock before you plan Week 1.

ItemWhy you need itTypical price (estimate)Needed?
BeagleBone Black Rev C (AM3358, 512 MB RAM, 4 GB eMMC)The board.US$60 to 110; prices vary widely by seller (checked 22 Nov 2026)Yes
microSD card, 16 GB or largerBoot, recovery and update drills$8Yes
3.3 V USB-to-serial cable for the 6-pin debug headerA console that works when the network does not$15 to 25Yes
5 V, 2 A power supply for the barrel jackUSB power alone can reset the board under load$8Yes
Breadboard, jumper wires, two push buttons, LEDs and resistorsLoopback wiring and the limit switch$12Yes
Ethernet cableNetwork access and updates$4Yes
8-channel USB logic analyzer that works with sigrok (typically 24 MHz sampling, about 40 ns resolution)An independent check of step timing at the 1 µs budget$12Yes
I2C temperature or humidity sensor breakout (for example a BME280 or TMP102 class)Week 6 and Phase 2 project 1$5Yes
5 V relay module or USB-controlled relay in the supply lineRepeatable power cuts in Phase 4, driven from your laptop$10Yes, from Week 13
Stepper driver module (A4988 or DRV8825 class), NEMA 17 stepper motor, 12 V supplyMoves real hardware. Check that your module accepts 3.3 V STEP and DIR levels (an A4988 takes its logic supply from VDD: use 3.3 V).$35 to 45Optional

The minimum kit (everything marked Yes, analyzer included) is about US$135 to 195 depending on the board price. Everything in the milestone works in loopback mode without the motor. A PocketBeagle (original) has the same AM335x PRUs in a smaller board. The newer PocketBeagle 2 uses a different chip (TI AM62x family, about US$29) with a dual- or quad-core Arm Cortex-A53, a Cortex-M4F core and a PRU subsystem. The PRU idea carries over, but the firmware, memory map and toolchain differ from the AM335x, so Phase 3 does not run on it unchanged. Use it for the port estimate in the Week 15 memo.

RiskRule
Wrong voltage destroys a pinHeader pins are 3.3 V and not 5 V tolerant. Read the board manual before wiring any 5 V signal.
Motor supply damages the boardPower the motor driver from its own supply, share ground only, and never draw motor current from the header. Set the driver's current limit before you connect the motor.
Lost workIn Phases 1 to 3 flash only the microSD card and keep the eMMC image as your known-good fallback. Back up the eMMC image before Phase 4, where ADR-5 decides what boots from where.
Wrong memory write hangs the boardAvoid writing /dev/mem by hand. Use remoteproc, RPMsg and kernel interfaces.
Power-cut drills corrupt storageRun them on a sacrificial microSD card (and a backed-up eMMC), on your own board only, through the relay.
SecurityThe BeagleBone Black has a general-purpose (GP) AM335x. It cannot do hardware secure boot. Plan for signed updates and a small attack surface instead (Week 15).